1. The driver of the dump truck in the factory must strictly abide by the "Road Traffic Management Regulations", "In-plant Traffic Safety Management Standards" and "Safety Production Code" on the way.
2. Before the vehicle starts, observe the surrounding conditions of the vehicle, and after confirming that it is safe and correct, (the car with the air brake waits for the reading of the air pressure gauge to reach the specified value) whistle and start. After starting, you should accelerate from slow to fast according to the operation essentials.
3. When using automatic dump trucks to transport goods, they should be loaded in a balanced manner according to the specified tonnage, and it is strictly forbidden to over-high, over-weight, and partial load. When loading large and heavy goods, the goods shall not be stuck on the carriage rails.
4. The automatic dumper is suitable for loading bulk deposits. When loading blocks, measures should be taken to avoid deformation of the carriage and damage to the locking mechanism during unloading. It is strictly forbidden to carry flammable and explosive crystals. .
5. Passengers are not allowed in the compartment, platform outside the cab, pedals, etc. of the dump truck, but 1 to 4 people can be attached to the loading and unloading personnel with an effective locking device.
6. Before unloading the automatic dump truck, you should carefully check whether there are wires or other obstacles above the truck, and dump it only after there is no person nearby. In special circumstances, special personnel should be set up to monitor the operation, and a sufficient safety distance should be maintained from the wires or obstacles above.
7. When loading materials from the excavator to the dump truck, no one is allowed to sit in the cab.
8. The lock pin should be pulled out before the lift of the dump truck.
9. The lifting operation of the dump truck should be stable, and it is not allowed to step on the accelerator, and it is forbidden to drive in the lifting state (except for the lifting and loading process).
10. It is not allowed to rule out the failure of the opening mechanism of the carriage when the carriage is lifted. If repairs are necessary, support the carriage with struts to prevent it from falling suddenly.
11. When unloading, the automatic dumper should choose a flat site, keep a corresponding safety distance from the edge of the pit and the ditch when unloading into the pit and ditch, and set up blocking piers to prevent the car from overturning. When unloading the truck in a particularly dangerous area (edge of high slope, etc.), there should be a special person in charge of the safety supervision work.
12. The falling operation of the carriage of the automatic dump truck should be stable, and it is not allowed to fall while walking. After dumping, lock the dump door and place the lever in neutral.
